我与乡下少妇的性事_色琪琪综合男人的天堂aⅴ视频_大胸喂奶秘书3p高h_国产一区二区视频在线播放_国产老头gay和老头gay视频_中文字幕亚洲欧美_国产男人搡女人免费视频_伊人色综合久久天天五月婷_崔雪莉被金秀贤握胸动态图_毛片在线视频观看

首頁 > 標準下載>IEC 62271-110-2017 高壓開關設備和控制設備--第110部分:電感負載開關 High-voltage switchgear and controlgear – Part 110: Inductive load switching免費下載
IEC 62271-110-2017 高壓開關設備和控制設備--第110部分:電感負載開關 High-voltage switchgear and controlgear – Part 110: Inductive load switching IEC 62271-110-2017 高壓開關設備和控制設備--第110部分:電感負載開關 High-voltage switchgear and controlgear – Part 110: Inductive load switching

IEC 62271-110-2017 高壓開關設備和控制設備--第110部分:電感負載開關 High-voltage switchgear and controlgear – Part 110: Inductive load switching

  • 標準類別:
  • 標準大?。?/li>
  • 標準編號:IEC 62271-110-2017
  • 標準狀態:現行
  • 更新時間:2023-11-11
  • 下載次數:
標準簡介

This part of IEC 62271 is applicable to AC switching devices designed for indoor or outdoor installation, for operation at frequencies of 50 Hz and 60 Hz on systems having voltages above 1?000 V and applied for inductive current switching. It is applicable to switching devices (including circuit-breakers in accordance with IEC 62271-100) that are used to switch high-voltage motor currents and shunt reactor currents and also to high-voltage contactors used to switch high-voltage motor currents as covered by IEC 62271-106. Switching unloaded transformers, i.e. breaking transformer magnetizing current, is not considered in this document. The reasons for this are as follows:
a) Owing to the non-linearity of the transformer core, it is not possible to correctly model the switching of transformer magnetizing current using linear components in a test laboratory. Tests conducted using an available transformer, such as a test transformer, will only be valid for the transformer tested and cannot be representative for other transformers.
b) As detailed in IEC TR 62271-306, the characteristics of this duty are usually less severe than any other inductive current switching duty. Such a duty may produce severe overvoltages within the transformer winding(s) depending on the re-ignition behaviour of the switching device and transformer winding resonance frequencies. NOTE 1 The switching of tertiary reactors from the high-voltage side of the transformer is not covered by this document.
NOTE 2 The switching of shunt reactors earthed through neutral reactors is not covered by this document. However, the application of test results according to this document, on the switching of neutral reactor earthed reactors (4-leg reactor scheme), is discussed in IEC TR 62271-306.dition 4.0 2017-10 INTERNATIONAL STANDARD NORME INTERNATIONALE High-voltage switchgear and controlgear – Part 110: Inductive load switching Appareillage à haute tension – Partie 110: Man?uvre de charges inductives IEC 62271-110:2017-10(en-fr) THIS PUBLICATION IS COPYRIGHT PROTECTED Copyright ? 2017 IEC, Geneva, Switzerland All rights reserved. Unless otherwise specified, no part of this publicat

標準截圖
下一條:返回列表
版權:如無特殊注明,文章轉載自網絡,侵權請聯系cnmhg168#163.com刪除!文件均為網友上傳,僅供研究和學習使用,務必24小時內刪除。